Polaris - Kit-Service Hub W/Bearing - 2204717

Well the problem was that when I jacked up my RZR, the front wheel would flop up, down, left and right. I took the tire off, took the brake caliper off and then I was able to remove the cotter pin and take the castle nut off and then noticed that the shaft coming off of the hub and going inside the bearing was broken. Removed upper and lower ball joints, removing steering tie rod. Pulled the hub out removed the ring that goes around the front of the bearing and then pressed out the old and pressed in the new. Then pressed lug bolts into the new hub and then reinstalled everything and now it works fine. I will say I don't recommend trying anything else except pressing in the bearings and the lug bolts. I tried doing other tricks like freezing and baking them and after getting upset the carrier ended up cracking. So if you don't have a press just pay to have it presses in otherwise you could damage the carrier.

I replaced a bad wheel bearing on my 09 RZR. Getting to the bearing is simple,I opted to get the bearing out the old fashion way. Used two blocks of wood and drove the old bearing out using a hammer and flat nose punch. I opted to use a press to go back in with the new. Fairly simple job when using a press. Overall I believe it is a fairly simple job. Re-installed the hub and was back up and running in a couple of hours.