Triumph - Light Bar Only - A9733475

How to pull a wire harness through a bending steel pipe
1st: use a thick enough wire to thread through the two openings
2nd: snip off attachments on end that needs to snake through & lay about three inches of the threaded wire over wire harness end that needs to go through.
3rd: wrap any kind of thread seal tape TIGHTLY around both harness & the wire (no need to bend the wire, or wrap wire around harness)
4th: at SAME time pull wire & push harness SLOWLY at SAME tensions
5th: Say 'f..kyea under your breath, or loudly if you want, then attach new fittings to where old ones were clipped off.
HELPFUL HINT: write down where each color wire connects to before you detach anything.